Installation on re node for version junos-evo-install-ptx-x86-64-20.4R2.14-EVO started. Setting up swapspace version 1, size = 4 GiB (4294963200 bytes) Mkswap: /dev/sda3: warning: wiping old swap signature. Processing /data/var/opt_fs for mount on /data/var/external. Processing /dev/sda7 for mount on /data/var.
Processing /dev/sda6 for mount on /data/config. Installing/Mounting on disk /dev/sda mapped to device ata1 Writing new partitioning table to disk sda. watchdog: watchdog0: watchdog did not stop!įound 186 gig (195360984 kbytes) Vendor ATA, Model SFSA200GM3AA4TO. jnx-cbd-fpga jnx-cbd-fpga.8: jnx_cbc_probe: FRU not handled by jnx-connector: -22! jnx-cbd-fpga jnx-cbd-fpga.10: jnx_cbc_probe: FRU not handled by jnx-connector: -22! Version is junos-evo-install-ptx-x86-64-20.4R2.14-EVO, Product is ptx.
#BOOT FROM USB USING RUFUS MAC OS X#
Using either a Microsoft Windows or a Mac OS X device and then use that USB If you have not yet created a USB drive, follow the instructions at Create a Bootable USB Drive Using a Windows Device or Create a Bootable USB Drive Using a MAC OS X to create a USB drive The secondary Routing Engine then reboots and
#BOOT FROM USB USING RUFUS SOFTWARE#
Request system software sync all-versions Primary Routing Engine to the secondary Routing Engine, use the To synchronize the software and configurations from the
If your system contains two Routing Engines, the secondary Routing Engineīoots up, but does not join the system formed by the primary RoutingĮngine and the FPCs, because the current software versions areĭifferent. Guide for your product and then continue to add the configuration Start with the initial configuration steps as described in the hardware If you do not have a previously-stored configuration file, you must See Restore the Configuration from a Backup Copy after a USB Software Installation. Hopefully, you previously stored a configurationįile on a remote server or other off-box location. If your system contains only one Routing Engine, you need to re-create Therefore, after the USB installation process completes: The USB installation process deletes all configuration and other files.
0 kommentar(er)
